Standalone Control Interface Box w/Pass-Thru

It's here...Zengineering's new RS232 Control Interface Box.

They allow "standalone" control of your Red LED Mallincam Camera, while allowing Pass-Thru to your PC.

Now you can control your camera via the HandBox, and with the flick of a couple switches, via your PC/Mac!!

No need to unplug cables, or disturb your finely tuned setup!!

The Control Box configuration seen above is ideal if you want to use your existing Control Cable.

Simply plug the control cable into the Pass-Thru port and connect the other end to your PC/MAC.

---------------------------

If you own an AIO Cable you could purchase a control box with a longer Pass-Thru cable (length "B")...

This will allow you to loop back to your AIO cable (at the camera) to have control of your camera at the scope...

While still sending each the AIO Cable signals to your pc, potentially far away.

---------------------------

Note: The Control Interface Box cannot be used at the PC end of an AIO cable!!

Works with MCHP, VSS+, and Xtreme cameras with the RS232 Interface.

Control Interface Box w/Pass-Thru (or without)

Now you can use the Handbox and have Full PC control with the flick of a switch!!

All-In-One (AIO v2) Pass-Thru Cable

An AIO pass-thru is a shorter cable designed to stay with your mount and

ideally would be just long enough to allow plenty of "play"  as your mount slews.

Zengineering's AIO Pass-Thru cables are available in many configurations,

but come standard as follows:

Composite/BNC (includes BNC coupler M/M)

Cat5e Pass-Thru (includes RJ45 Coupler, F/F)

Mallincam Control

12v Power

Leave it attached to your telescope/camera/mount, etc. to minimize disturbance to your valuable setup.

Then connect your longer AIO (Including v2) cable to the pass-thru cable for extreme ease of operation.

Available in custom lengths from 3' on up...

Control Cable Pass-Thru Cable

Works with a standalone Control Box (with or without Pass-Thru) as well as for PC Control.

This is usually a shorter cable designed to be just long enough to allow plenty of "play"  as your mount slews.

Leave it attached to your telescope-camera-mount, etc. to minimize disturbance to your valuable setup.

Then connect your longer Control Cable to the pass-thru cable for extreme ease of operation.

Available in custom lengths from 3' on up...

For custom cable lengths, simply select the next highest length from above.

Leave a note in the paypal cart with specific length you would like.

Example: You want a 10' Control Cable Pass-thru cable...you would purchase a 25' Control Cable Pass-thru cable.

Or you want a 35' Control Cable Pass-thru cable...You would purchase a 50' Control Cable Pass-thru cable, etc.

Contact me with any questions parallax_m42@hotmail.com

Cable Adapters

BNC Male to BNC Male Adapter

-------------

BNC Male to RCA Adapter

------------

Svideo to RCA Adapter